Bathtub Refinishing
Bathtub refinishing Bonita Springs FL that looks factory-new
Bathtub refinishing Bonita Springs FL homeowners call us for is a same-day fix for a tub that has gone dull, chipped, or stained. We sand, repair, and spray a new finish over your existing tub instead of tearing it out. Most jobs are done in three to five hours, and the tub is ready for use in 24. If your tub is sound but ugly, this is the cheapest way back to a clean bathroom.
Service overview
What bathtub refinishing Bonita Springs FL actually involves
Bathtub refinishing Bonita Springs FL is a coating process that bonds a new acrylic-urethane surface to your existing tub, sink, or tile. We start by cleaning and degreasing the old surface, then grind out chips and cracks with an oscillating multi-tool and fill them with a two-part epoxy. A bonding agent goes down next, followed by three to four sprayed coats of the finish. The result is a non-porous surface that resists soap scum and hard water stains.
Most of our calls come from homes built in the 1980s and 1990s around Pelican Landing and Spanish Wells, where the original cultured marble or American Standard tub has yellowed or lost its gloss. Others call after a cracked bathtub finish shows up near the drain. If you have been searching bathtub refinishing near me Bonita Springs, the fix is usually one visit, not a demolition crew.
Practical benefits
Why homeowners choose refinishing over replacement
Replacing a tub means tearing out tile, moving a shower valve, and repairing drywall. Refinishing skips all of it. Here is what you actually get when you book tub reglazing in Bonita Springs, Florida.
A fraction of replacement cost
A full tub replacement with tile work runs $3,500 to $7,000 in Lee County. Bathtub reglazing Bonita Springs FL pricing lands between $450 and $850 for a standard alcove tub. You keep the same footprint, the same plumbing, and the same tile surround, and you put the savings into a new vanity or faucet instead.
Done in a single day
Our crew is in and out in three to five hours. The finish cures overnight and you can shower the next morning. Compare that to a replacement, which means three to five days of dust, a porta-potty conversation, and a bathroom you cannot use. One visit, one invoice, one clean tub.
Covers chips, cracks, and rust
We grind out every chip down to bare substrate, treat rust spots with a primer, and fill cracks with epoxy before any topcoat goes on. That is why a refinished tub does not peel at the drain the way a cheap DIY kit does. We also reseal the overflow and drain gasket while we are in there.
Holds up to Florida humidity
Bonita Springs bathrooms run humid year-round, and that is hard on cheap coatings. We use a marine-grade topcoat that handles steam and daily cleaning without blistering. Pair it with a working exhaust fan and the finish lasts 10 to 15 years with normal use.
How service works
How our refinishing process works
Five steps, one visit, no surprises. Here is exactly what happens from the moment we pull into your driveway until the tub is ready to use again.
STEP 01
Walkthrough and prep
We cover the floor, vanity, and toilet with drop cloths, tape off the tile line, and pull the drain screen. If your tub has a failing shower valve or a slow drain, we flag it before we start so you are not surprised later. Prep takes about 30 minutes.
Tools and methods
Tools and methods we use
HVLP spray gun
Applies the acrylic-urethane topcoat in thin, even coats. Sprayed finishes bond better and look smoother than brushed or rolled coatings, and they do not leave roller marks.
Oscillating multi-tool
Grinds out chips, cracks, and rust spots down to bare substrate before we fill them. This is the step that separates a lasting repair from a coating that peels in a year.
Moisture meter
Checks the subfloor and surrounding drywall for hidden water before we spray. If there is moisture behind the tub, refinishing is a waste of money until the leak is fixed.
Shop vacuum
Pulls every bit of dust and grit out of the tub after sanding. Any grit left behind shows up as a bump in the finish, so we vacuum before every coat.
Caulking gun
Applies silicone sealant around the drain, overflow, and tub-to-tile line. A clean bead keeps water out of the wall cavity, which is where most bathroom damage starts.
Two-part epoxy repair
We fill chips and cracks with a two-part epoxy, not a one-part filler. Epoxy cures harder, sands smoother, and does not shrink. It is the same approach body shops use on cars, and it is why our repairs do not show through the topcoat.
Acrylic-urethane topcoat
We spray an acrylic-urethane finish in three to four coats. It handles steam, daily cleaning, and Florida humidity without blistering. We choose the topcoat based on the tub material and the ventilation in your bathroom.
ANSI A118.10 waterproofing standard
We follow the ANSI A118.10 standard for waterproofing membrane installation on every job where we tie into tile or a shower surround. It is the same standard we use on full bathroom remodels, and it keeps water where it belongs.
EPA Lead-Safe work practices
For homes built before 1978, we follow EPA Lead-Safe Certified Firm procedures. That means containment, HEPA vacuuming, and proper disposal. It protects your family and it keeps the job compliant with federal rules.
Where this service fits
When to book bathtub refinishing
You are selling your Bonita Springs home and the tub looks tired in listing photos.
We refinish the tub in one visit, usually within a week of your call. The new finish photographs like a new tub, and it costs a fraction of what a replacement would run. We can work around your showing schedule. Your listing photos show a clean, glossy tub, and you avoid a price negotiation over a bathroom that looked dated.
You manage a rental and the tub has chipped between tenants.
We grind out the chips, fill them with epoxy, and spray a fresh topcoat. The whole job is done in a day, so you do not lose a week of rent. We also check the exhaust fan while we are there. The unit is back on the market in 48 hours with a tub that looks new, and you have a written warranty on file.
You are remodeling the bathroom but the tub is still in good shape.
We refinish the tub to match the new tile, vanity, and fixtures instead of pulling it out. That saves the cost of demolition, a new tub, and new tile around the alcove. We coordinate with your other trades. The whole bathroom reads as new, and you saved $3,000 or more versus a full tub replacement.
Your tub has a cracked finish near the drain and you are worried about water damage.
We inspect the crack, check the subfloor with a moisture meter, and repair the finish with epoxy and a fresh topcoat. If the subfloor is wet, we tell you and scope the repair before we spray. The crack is sealed, the finish is restored, and you know whether there is hidden water damage before it becomes a mold problem.
Local execution
How bathtub refinishing runs in Bonita Springs
Bonita Springs bathrooms take a beating. The humidity runs high most of the year, and hard water leaves mineral deposits on every surface. That combination is hard on tub finishes, which is why so many homes around Pelican Landing and Spanish Wells end up needing tub refinishing Bonita Springs FL homeowners can trust. We spec a marine-grade topcoat and a longer cure time to handle the local climate. Building stock matters too. A lot of the homes we work in were built in the 1980s and 1990s with cultured marble or American Standard tubs, and those finishes have a known lifespan. We also work in newer builds at Bonita National and Copperleaf, where the tub is fine but the finish has dulled from cleaning products. If you are searching bathtub refinishing in Weeks Fish Camp Bonita Springs FL, we cover that area and the rest of Lee County. We pull permits when the scope requires it and we work to Florida Building Code on every job.
Pelican Landing
Many homes here have original 1990s tubs with cultured marble surrounds. We refinish the tub and reseal the surround in one visit.
Spanish Wells
Older housing stock with cast iron tubs that hold up well but lose their finish. Cast iron takes a longer cure time, which we build into the schedule.
Bonita Bay
High-rise condos with strict HOA rules on work hours and elevator use. We schedule around building requirements and keep the job quiet.
Weeks Fish Camp
Cottages and older homes close to the water. Salt air and humidity speed up finish degradation, so we spec a heavier topcoat here.
Bonita National
Newer construction where the tub is sound but the finish has dulled. A one-day refinish brings it back without touching the tile.
Year-round humidity above 70 percent
Humidity slows cure time and stresses cheap coatings. We add cure time to the schedule and check that your exhaust fan is pulling air before we spray.
Hard water with high mineral content
Minerals etch the finish over time and leave stains that scrubbing will not remove. We etch the surface during prep and spray a non-porous topcoat that resists deposits.
Older homes with cast iron tubs
Cast iron holds heat and takes longer to cure. We adjust our schedule and cure times for cast iron so the finish bonds properly.
HOA rules on work hours and elevator use
Many Bonita Springs communities restrict when contractors can work. We schedule around those rules and coordinate with building management ahead of time.
Problems we solve
Problems our refinishing service solves
Most tubs we see in Bonita Springs are not broken. They are ugly, stained, or chipped, and the homeowner assumes replacement is the only fix. Here are the problems we solve every week.
Tub surface is dull, yellowed, or stained
We refinish the tub with a fresh acrylic-urethane topcoat in the color you choose. The new surface is non-porous, so it resists soap scum and hard water stains. Most tubs look factory-new when we are done, and the whole job takes one visit. A yellowed tub makes the whole bathroom look dirty, even after you clean it. It also drags down resale value because buyers notice it immediately on a walkthrough.
Chips and cracks near the drain or overflow
We grind out the chip to bare substrate, fill it with two-part epoxy, sand it flush, and prime it before the topcoat. The repair is invisible when we are done. We also reseal the drain and overflow gasket while we are in there. A chip exposes the substrate underneath, and in a humid bathroom that means rust and further cracking. Left alone, a small chip becomes a replacement job within a couple of years.
Rust stains around the drain
We treat rust spots with a primer, fill the area with epoxy, and spray a fresh topcoat over the whole tub. If the rust has reached the subfloor or the tub flexes underfoot, we tell you straight that replacement is the better call. Rust means water is getting under the finish. If you ignore it, the tub will eventually fail at the drain, and that means water in the subfloor and a much bigger repair bill.
Hard water stains on the tub floor
We etch the surface as part of prep, which removes the mineral layer, then spray a new non-porous topcoat that resists future deposits. We also give you a care sheet with the right cleaners to use so the finish stays glossy. Bonita Springs water is hard, and it leaves mineral deposits that etch into the finish. Once the surface is etched, no amount of scrubbing brings the gloss back.
A practical standard for every visit.
Clear planningPrepared arrivalsCareful workLocal follow-through
Experience in the details
Local experience you can check
We have refinished tubs across Lee County for years, from Bonita Bay high-rises to single-family homes off Imperial River. Our techs are trained on HVLP spray systems and two-part epoxy repair, and we work to Florida Building Code and ANSI A118.10 standards on every waterproofing detail. We carry EPA Lead-Safe certification for pre-1978 homes, which matters in older Bonita Springs neighborhoods. We are a state-licensed contractor, fully insured, and every refinish job carries a written warranty. If a coating fails inside the warranty window, we come back and fix it.
- EPA Lead-Safe Certified Firm for pre-1978 homes
- State-licensed contractor, fully insured and bonded
- HVLP spray systems and two-part epoxy repair on every job
- ANSI A118.10 waterproofing standard applied to every refinish
- Written warranty on all bathtub refinishing work
Where we work
One local team. A lot of ground covered.
Downtown Bonita SpringsBonita Springs City CenterBonita BayPelican LandingPelican MarshSpanish WellsImperial RiverBonita NationalVanderbilt BeachBarefoot BeachBonita BeachCoconut Point
Check my address Most standard alcove tubs run $450 to $850 in 2026, including prep, chip repair, and the spray finish. Tile surround refinishing adds $150 to $400. Walk-in tubs and clawfoot tubs cost more because of the extra surface area. We quote a flat number after seeing the tub, so there is no hourly surprise on the invoice.
Expect 10 to 15 years with normal use and proper cleaning. The two things that kill a finish early are abrasive cleaners and a bathroom with no working exhaust fan. Bonita Springs humidity is hard on coatings, so we always check your ventilation before we spray. If you keep the fan running and use a non-abrasive cleaner, the finish holds.
Look for three things: EPA Lead-Safe certification, a written warranty, and a crew that preps with an oscillating multi-tool and epoxy filler instead of a paint roller. We carry all three. Ask any contractor you call what they use for chip repair. If the answer is caulk or a one-part filler, walk away.
If your tub is structurally sound and the problem is cosmetic, yes. You save $3,000 or more versus replacement, you keep your tile and plumbing, and you get a clean tub in one day. If the tub flexes underfoot or the subfloor is soft, replacement is the better call and we will tell you that upfront.
Keep exploring
Related services
Your next step is waiting
Book bathtub refinishing Bonita Springs FL this week
One visit, one flat price, one clean tub. We are licensed, insured, and we back every refinish with a written warranty. Call now and we will get you a same-day estimate.
Start with the basics
Get Your Free Bathroom Estimate
Call us at 512 325 0295 or send a message and we will get back to you the same business day. We answer the phone Monday through Friday, 8:00 to 6:00, and we book most estimates within the week. Tell us what is going on with your bathroom and we will tell you what it takes to fix it.